Q-Logic 59022-11 A 4-13, SANBOX2-16 manual Active Zone Set Data Window

0	3 – Managing Fabrics
	Displaying Fabric Information

3.5.4

Active Zone Set Data Window

The Active Zoneset data window displays the zone membership for the active zone set that resides on the fabric management switch. The active zone set is the same on all switches in the fabric – you can confirm this by adding a fabric through another switch and comparing Active Zone Set displays.

To open the Active Zoneset data window, click the Active Zoneset tab below the data window in the topology display. Refer to ”Configured and Active Zonesets Data Window” on page 4-14for information about the zone set definitions on a particular switch. Refer to ”Zoning a Fabric” on page 3-37for more information about zone sets and zones.

The Active Zoneset data window, shown in Figure 3-13, uses display conventions for expanding and contracting entries that are similar to the fabric tree. An entry handle located to the left of an entry in the tree indicates that the entry can be expanded. Click this handle or double-click the following entries:

„A zone set entry expands to show its member zones.

„A zone entry expands to show its member ports/devices.

„Ports/devices that are zoned by WWN or FC address, but no longer part of the fabric, are grayed-out.

Active Zoneset

Data Window

Figure 3-13. Active Zone Set Data Window

59022-11 A 3-33