Q-Logic 59022-11 A 4-13, SANBOX2-16 manual Table A-21. Set Config Threshold Parameters

0	A – Command Line Interface
	Set Config Command

threshold

Initiates a configuration session by which to generate and log alarms for selected events. The system displays each event, its triggers, and sampling window one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. These parameters must be saved in a configuration and activated before they will take effect. Refer to the ”Config Command” on page A-16for information about saving and activating a configuration. Table A-21describes the Set Config Threshold parameters. The switch will down a port if an alarm condition is not cleared within three consecutive sampling windows (by default 30 seconds). Reset the port to bring it back online. An alarm is cleared when the threshold monitoring detects that the error rate has fallen below the falling trigger.

Table A-21. Set Config Threshold Parameters

Parameter		Description
Threshold Monitoring Enabled	Master enable/disable parameter for all
	events. Enables (True) or disables (False)
	the generation of all enabled event alarms.
	The default is False.
CRCErrorsMonitoringEnabled	The event type enable/disable parameter.
DecodeErrorsMonitoringEnabled	Enables (True) or disables (False) the
ISLMonitoringEnabled	generation of alarms for each of the
LoginMonitoringEnabled	following events:
LogoutMonitoringEnabled	„	CRC errors
LOSMonitoringEnabled	„	Decode errors
	„	ISL connection count
	„	Device login errors
	„	Device logout errors
	„ Loss-of-signal errors
Rising Trigger	The event count above which a rising
	trigger alarm is logged. The switch will not
	generate another rising trigger alarm for
	that event until the count descends below
	the falling trigger and again exceeds the
	rising trigger.
Falling Trigger	The event count below which a falling
	trigger alarm is logged. The switch will not
	generate another falling trigger alarm for
	that event until the count exceeds the
	rising trigger and descends again below
	the falling trigger.
Sample Window	The period of time in seconds in which to
	count events.

59022-11 A A-65