
Chapter 3 Multi-Track Recording
When You Are Recording in Stereo
When recording in stereo, or when recording to tracks with Channel Link (p. 149) on, you can set the pan for each input channel. After Step 5, per- form the procedure described below.
The SELECT indicator lights.
] [
] several times until “MIX Sw” appears in the dis- play.
MIX Sw (Mix Switch)
This selects the bus to which the source or track output will be assigned. For this example select “On.”
On: The source or track will be sent to the mix bus. Set this to “On” when, for example, you simply want to mix the inputs without recording the source. However, the sources that are assigned to the RECORDING bus are disabled.
Off: The source or track will not be assigned to the mix bus. If it is not assigned to a record- ing bus either, then that source/track will not be output anywhere.
].
MIX Pan
This adjusts the pan setting
Return to Play condition.
Saving a Recorded Performance (Song Store)
The contents of any recorded performance will be lost if you simply turn the power off, or even if there is an accidental power failure or power outage. Once lost,
the contents of a recorded performance cannot be
restored to the previous conditions. To avoid this from happening, use the following procedure to save your songs to the disk.
*When handling important song data, or when using the
1.Hold down [SHIFT] and press [STORE (ZERO)].
2.“STORE OK?” appears in the display. If you are satisfied with the results of your recording, press [YES]. If you wish to cancel the save, press [NO].
*The contents of the demo songs are protected from being changed or overwritten (Song Protect (p. 64)). You can- not save operation with the demo songs. This means if you press [YES] at Step 2 when a demo song is selected, the message “Song Protected” will appear, and the procedure cannot be continued.
Chapter 3
43