Chapter 10 Use with a DAT Recorder (DAT Backup)
10.The display will indicate “Init ***:* OK ?” (OK to initialize the current drive?). “***:*” will show “IDE:*” for the internal hard disk, or
11.If you wish to initialize the current drive and then recover, press [YES]. If at this point you press [YES], all songs saved on the internal hard disk will be lost. If you decide not to initialize, press [NO].
12.“Please Play DAT” appears in the display.
Put the DAT recorder in play mode.
13.Load the data. If you have backed up the data to multiple tapes, then the operation is suspended when the end of each tape is reached. Insert the number tape indicated in the display, press [YES], and start the DAT recorder playing again.
14.When the recover procedure is finished, “Please Stop DAT” appears in the display. Stop the DAT recorder, then press [YES].
15.Press [PLAY (DISPLAY)].
Return to Play condition.
When Canceling the Recover
Operation
You can stop the recover operation by pressing [EXIT (NO)] during the recover. Moreover, when there is an error in song data backed up on a tape, the recover operation is temporarily halted. In such instances, you can choose whether to leave or delete the (unfinished) song data recovered up to that point.
*This procedure does not correct the disk error, but tries to restore the song data while keeping as much possi- ble of the
*Loud noises may damage your audio equipment such as amplifier and speakers. Please make sure to turn down the headphones level and master volume of the
Canceling a DAT Recovery Operation in Progress
1.Press [EXIT (NO)] during the DAT recovery. Recovery is stopped, and “Delete Err Song?” (Delete the song containing the error?) appears in the display.
2.If you would like to delete from the hard disk the song data that stopped the recovery operation, press [YES]. If you would like to keep it as it is though the recovery is not completed, press [NO].
When an Error is Found in the Song Data
1.If an error is found in the song data which was recovered with the DAT recovery operation, “Recover Err Retry?”(An error was found. Retry the song?) appears in the display.
2.If you want to try to recover the data, press [YES]. If you want to cancel the recovery, press [NO].
3.If you press [NO] in Step 2, “Delete Err Song?” then appears in the display.
4.If you would like to delete the song data with the error from the hard disk, press [YES]. If you would like to keep it as it is though the error is included, press [NO].
