Schneider Electric HRB1684301-01 Chapter Front panel display and meter setup, Front panel LEDs

PowerLogic™ PM5500 series user manual	Chapter 3—Front panel display and meter setup
Chapter 3	Front panel display and meter setup

This section applies to meters that are equipped with a front panel display. The front panel display lets you use the meter to perform various tasks such as setting up the meter, displaying data screens, acknowledging alarms, or performing resets.

Parts of the display

G F E

D

ANavigation / menu selection buttons

BHeartbeat / communications LED (green)

CAlarm / energy pulsing LED (orange)

DNavigation symbols or menu options

ERight notification area

FScreen title

GLeft notification area

HCursor

C

LED indicators

The meter has two LED indicators on the front panel.

Front panel LEDs

C Alarm / energy pulsing LED (orange)

Heartbeat / communications LED (green)

NOTE: For the PM5561 model, the alarm / energy pulsing LED is factory set for energy pulsing only and cannot be modified or disabled.

Heartbeat / communications LED

The (green) heartbeat / communications LED blinks at a slow, steady rate to indicate the meter is operational. The LED flashes at a variable, faster rate when the meter is communicating over a Modbus serial communications port.

You cannot configure this LED for other purposes.

NOTICE

UNINTENDED EQUIPMENT OPERATION

A heartbeat LED that remains lit and does not blink (or flash) indicates a hardware problem. In this case, power down the meter and reapply power. If the LED still does not blink or flash, contact Technical Support.

Failure to follow these instructions may render your device inoperable.

HRB1684301-01 31