Schneider Electric HRB1684301-01 user manual LED alarm indicator

PowerLogic™ PM5500 series user manual Chapter 10—Alarms

LED alarm indicator

You can use the meter’s alarm / energy pulsing LED as an alarm indicator.

Location of alarm / energy pulsing LED

PM5560 / PM5561 PM5563 A Alarm / energy pulsing LED

When set to detect alarms, the LED blinks to indicate an alarm condition. See “Alarm priorities” on page 94 for a description of the LED behavior based on different alarms.

NOTE: The alarm / energy pulsing LED on the PM5561 is permanently set for energy pulsing and cannot be used for alarms.

Configuring the LED for alarms using the meter display

You can use the meter display to configure the alarm /energy pulsing LED for alarming.

Maint	Reset
	Setup	Meter
		Comm
		Alarm
		I/O	LED	D In	D Out	Inp Mtr

1.Navigate to the LED setup menu screen.

Alarm / energy pulsing LED setup parameters

Setting	Option or range	Description
		Disabled turns off the LED completely.
Mode	Disabled, Alarm, Energy	Alarm sets the LED for alarm notification.
		Energy sets the LED for energy pulsing.
	Active Del,
	Active Rec,
	Active Del + Rec,	Select which accumulated energy channel to monitor and
Parameter	Reactive Del,
		use for energy pulsing. This setting is ignored when the
	Reactive Del + Rec,
		LED mode is set to Alarm.
	Apparent Del,
	Apparent Rec,
	Apparent Del + Rec
		When configured for energy pulsing, this setting defines
Pulse Wt. (p/k_h)	1 to 9999999	how many pulses are sent to the LED for every 1 kWh,
		1 kVARh or 1kVAh accumulated energy. This setting is
		ignored when the LED mode is set to Alarm.

2.Set the mode to Alarm, then press OK.

3.Press to exit. Press Yes to save your changes.

HRB1684301-01 99