Schneider Electric HRB1684301-01 user manual Configuring digital inputs using the front panel

PowerLogic™ PM5500 series user manual Chapter 8—Input / Output

6.Configure the other setup parameters as required.

7.Click Send to save your changes.

Digital input setup parameters available through ION Setup

Parameter	Values	Description
Label	—	Use this field to change the default label and assign a
		descriptive name to this digital input.
		This field displays how the digital input functions.
		• Normal: the digital input is either associated with a
		digital input alarm, or it is not associated with
		another meter function. The meter counts and
		records the number of incoming pulses normally.
		• Demand Sync: the digital input is associated with
		one of the input sync demand functions. The meter
Control Mode	Normal, Demand Sync, Input	uses the incoming pulse to synchronize its demand
	Metering, Multi-Tariff	period with the external source.
		• Input Metering: the digital input is associated with
		one of the input metering channels. The meter
		counts and records the number of incoming pulses
		and related consumption data associated with the
		pulses.
		• Multi-Tariff: the digital input is associated with the
		multi-tariff function. See “Input mode overview” on
		page 105.
		Debounce is the time delay that compensates for
		mechanical contact bounce. Use this field to set how
Debounce	0 to 1000	long (in milliseconds) the external signal must remain in
		a certain state to be considered a valid state change.
		Allowable values are increments of 10 (i.e., 10, 20, 30,
		etc., up to 1000 ms).
Associations	—	This field displays additional information if the digital
		input is already associated with another meter function.

Configuring digital inputs using the front panel

You can use the front panel to configure the digital inputs.

Digital input setup menu tree

Maint	Reset
	Setup	Meter
		Comm
		Alarm
		I/O	LED	D In	D Out	Inp Mtr

1.Navigate to Maint > Setup.

2.Enter the setup password (default is “0”), then press OK.

3.Navigate to I/O > D In.

4.Move the cursor to point to the digital input you want to set up, then press Edit.

5.Move the cursor to point to the parameter you want to modify, then press Edit.

NOTE: If Edit is not displayed, it means the parameter is either read-only or can only be modified through software.

6.Modify the parameter as required, then press OK.

HRB1684301-01 71