Siemens 6AU1900-1AB32-0BA0 configurationmanual Properties

Configuring

3.5Customize the display of the cam

3.Either the window Master Properties (for the master axis) or the window S Diagram Properties (Slave) (for the slave axis) is displayed.

For the master axis, change the representation parameters in the window Master Properties.

Figure 3-11 Master Properties window

For the slave axis, change the representation parameters in the window S Diagram (Slave)

Properties.

Figure 3-12 Slave Properties window
Table 3-2		Parameters in the Master Properties or S Diagram (Slave) Properties
		Field/button	Explanation/instructions
Master Range			You specify the master range (definition range) of the curve
(Master Properties)			via start and end points. Cam segments must lie within this
			master range (see also Master range under Target device
			properties in the Coordinates tab).
	Start		Enter the start point of the curve, or the start of the master
			range of the curve here.
	End		Enter the end point of the curve, or the end of the master
			range of the curve here.

3-18	CamTool
	Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0