Siemens 6AU1900-1AB32-0BA0 configurationmanual Target device parameters, Coordinates

Functions 4.9 Specify parameters for target device

Notice

If you specify a scaling, you can show and hide the scaled curve via the menu Cam > Representation parameters > Display scaling.

If the scaled curve is displayed, you cannot edit the original curve in the diagram displays.

4.9.2Target device parameters

coordinates

Specify the coordinates for the target device here.

You can set the following parameters:

Table 4-4		Parameters in the Coordinates tab (Target Device Parameters window)
		Field/button	Explanation/instructions
Master Range			You specify the master range (definition range) of the curve via start and
			end points. Cam segments must lie within this master range (see also
			Master range under S Diagram (Master) properties).
	Start		Enter the start point of the curve, or the start of the master range of the
			curve here.
	End		Enter the end point of the curve, or the end of the master range of the
			curve here.
Execution type			The Execution type specifies the interpolation of the cam by the target
			device at the boundary points of the master range.
	Non-cyclic		If you select the Non-cyclicexecution type. The cam cycle ends when
			the end value of the curve is reached. The function values of the cam
			(slave position) at the start and end point of the master range are
			normally different.
			Note:
			If you activate Non-cyclic, the master range in the horizontal direction is
			displayed once.
	Cyclic absolute		If you select the cyclic absolute execution type, a return is made from the
			end value of the slave axis to the start point of the slave axis and the
			cam is repeated. The function values of the cam (slave position) at the
			start and end point of the master range are identical. Possibly an
			identical value (average value) is forced from the target device.
			Note:
			If you activate Cyclic absolute, the master range in the horizontal
			direction can be displayed repeatedly.

CamTool	4-31
Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0