Siemens 6AU1900-1AB32-0BA0 configurationmanual Slave tab, Functions

		Functions
		4.10 Specify simulation settings
	Field/button	Explanation/instructions
Master velocity for calculations
(Setting (axis))
(Setting: None)
	Gear ratio (relative)	If you activate this option, all calculations are based on
		relative values (values relative to the master axis).
	Use standard velocity	If you activate this option, the configured standard velocity
	(Setting (axis))	of the axis which you specified under Accept from axis is
		accepted. All calculations are based on absolute values.
	User-defined	If you activate this option, you must enter a velocity under
		V master. All calculations are based on absolute values.
	V Master	If you activate user-defined, you must enter the master
	(User-defined activated)	velocity under V master.

Slave tab

You specify here the simulation settings for the Slave tab.

You can set the following parameters:

Table 4-8		Parameters in the Slave tab (Simulation Settings window)
		Field/button		Explanation/instructions
Setting
	Accept from axis		•	(Axis)
				When you create the cam for an axis that already exists
				in the project, you can select the axis here. The
				configured values are taken over and displayed.
			•	None
				If you select None, you can specify all parameters.
Properties
(Setting: None)
	Linear axis		If you select this option, you simulate the slave axis as a
			linear axis.
	Rotary axis		If you select this option, you simulate the slave axis as a
			rotary axis.
	Modulo rotary axis		If you select this option, you simulate the slave axis as a
			modulo rotary axis.
	Type		Here you select the axis type.
	Unit of measure		Here you specify the unit of measure for the axis. Select a
			unit of measure or enter the unit of measure. The
			representation of the unit of measure is refreshed in the
			diagrams when you click Accept or OK.
			Note:
			The unit of measure is only used for the display. If the unit
			of measure is changed, the represented values are not
			converted.

CamTool	4-37
Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0