During the duration specified by the punch in/out function, the minimum level is stored as automation data for the corresponding fader.
At the punch in point, the current fader level is stored. At the punch out point, the fader level of the previous data is stored.
Previous automation data
New automation data
Event created automatically
Punch in point | Punch out point |
For items in WRITE mode, the events are created automatically at the punch in and punch out points.
When the settings have been completed and everything is ready to save them as data, select KEEP by touching the TITLE button on the window, as required.
Performing punch in/punch out using the foot switch
Punching in/punching out using the foot switch allows you to manually control the Drop in/out using an external foot switch.
To perform a cut operation, use the AUTOMATION buttons section on the Automation panel on the unit and in the AUTOMATION window.
For details of buttons, see “Automation Panel” on page 25, and for operations on the window, see “AUTOMATION Window” on page 68.
1 Select the FOOT SW button on the PUNCH IN/OUT section on the AUTOMATION window.
2 Press the ABS button on the TC AUTOMATION section on the Automation panel of the unit so that it lights up.
3
4 Drop in the fader whose signal you want to cut on the window. The display turns in red, but data will not be written until the foot switch is set to ON.
5 Press the SAFE button on the TC AUTOMATION section on the Automation panel of the unit so that it goes off.
(Continued)
4 Chaper Tips Operation
Chapter 4 Operation Tips 105