5Output select buttons

Touch the corresponding button to select the desired signal path for the oscillator signal.

6FREQUENCY SET buttons/GANG button/ display window

L SET/R SET buttons: Touch the SET button so that you can set the frequency of the L or R oscillator signal using the jog dial on the unit. The set frequency is displayed on the display window.

GANG button: Touch the GANG button so that you can adjust the frequency of the L and R oscillator signals in gang mode.

7LEVEL SET buttons/GANG button/display window

L SET/R SET buttons: Touch the SET button so that you can set the level of the L or R oscillator signal using the jog dial on the unit. The set level is displayed on the display window.

GANG button: Touch the GANG button so that you can adjust the level of the L and R oscillator signals in gang mode.

When selecting the TALKBACK tab

When the TALKBACK tab 3 is selected, buttons 4 and 5 act as control buttons for talkback signals. Buttons 6 are not effective.

4MEMORY button

When the MEMORY button is on, the active/inactive status of the talkback output select buttons 5 are stored. The buttons on the TALKBACK panel are then enabled to activate talkback to PGM, AUX SEND and MTR buses.

When the MEMORY button is off, the talkback signal of the built-in microphone is sent to the bus selected on the Talkback panel while holding down the corresponding output select button 5.

5Output select buttons

Touch the desired output select button so that the talkback signal is sent to the bus or connector selected by the output select button.

7LEVEL SET buttons/GANG button/display window

Touch the R LEVEL SET button to adjust the level of the talkback signal using the jog dial on the unit.

3 Chapter Menu

Chapter 3 Menu 63