Menu Windows
3 Chapter Menu
4Output connector select buttons
SLOT 1 to 4, AUX SEND 1 to 8, PGM, MONI OUT Selects the output connector to which the bus block is routed.
Each of SLOT 1 to SLOT 4 has 8 output connectors.
5INSERTION buttons
BUS buttons: Assigning an insert to an output bus is a 2 stage process. Firstly the output buses are assigned to internal INSERTION circuits (assigned by selecting each mono output bus from the block list and then touching the selected INSERTION button), second each insertion must be assigned to an output and an input on the two routing pages.
IN button: When IN is displayed on the button by touching it, the bus insert is active.
When OUT is displayed on the button, the insertion send signal is still outputted. However, the insertion return signal is not used.
Note
These inserts can be only assigned to bus signals (PGM, AUX SEND and MTR buses).
Assigning the bus
1 Touch the bus select button. The block list of the bus opens.
2 Touch the desired bus on the block list.
The list of the busses included in the selected block opens.
To select the busses by the block, go to step 4.
3 Touch the desired bus on the bus list.
4 Touch the output connector button to route the bus signal.
The bus signal selected in step 3 is routed to the output terminal selected in step 4.
You can route entire output block to an adjacent set of output connectors by simply selecting the block and then touching the first output connector button.
Example: When you select MTR 1 to 8 as a block,
if you touch this button of SLOT 1, the bus signals of MTR 1 to 8 are routed to SLOT 1 to SLOT 8 respectively.
Resetting the output matrix to the default setting
1 Touch the DEFAULT button. A dialog box appears.
2 Touch [OK] in the dialog box.
The setting of the output matrix is reset to the default setting.
For detailed information on the contents of the default setting, see page 90.
58 Chapter 3 Menu