Using the stereo signal
When setting PAN of the channel to OFF
1 Display “STEREO” on the MODE button by touching it on the INPUT/PAN/ASSIGN window (page 44).
2 Set the PAN button to OFF on the INPUT/PAN ASSIGN window.
3 Perform settings for the PROGRAM L/R buttons on the BUS ASSIGN section on the Parameter setting panel.
•For the L channels (usually the odd channels), set the PROGRAM L button to ON and the PROGRAM R button to OFF.
For the R channels (usually the even channels), set the PROGRAM R button to ON, and the PROGRAM L button to OFF.
You can also set the PROGRAM L/R bus on the ASSIGN section on the INPUT/PAN/ASSIGN window.
•Select the status of the REVERSE button, the L + R button and the MS DECODE button on the INPUT/PAN/ASSIGN window, as required.
When setting PAN of the channel to ON
1 Display “STEREO” on the MODE button by touching it on the INPUT/PAN/ASSIGN window (page 44).
2 Set the pan of odd and even channels to ON.
3 Set the PROGRAM L/R buttons in the BUS ASSIGN section on the Parameter setting panel to ON.
4 Turn the pan control of the odd channel fully counterclockwise.
5 Turn the pan control of the even channel fully clockwise.
6 Adjust the panning settings of the odd and even channels as required.
Note
For channels set in stereo, you have to perform pan/surround panning settings for L and R independently. Perform the pan/surround panning settings, as required.
4 Chaper Tips Operation
Chapter 4 Operation Tips | 93 |