3 Chapter Menu

Menu Windows

SYNC/TIME CODE Window

To open this window, touch the SYSTEM button on

This window allows you to control the settings of the

the bottom menu bar, then select “TIME CODE” on

reference signal and the timecodes used for

the menu.

automation.

1SAMPLING FREQUENCY buttons

2 SYNC CLOCK section

3 PLL status display section

4 CHANGE button

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6 MEASURE/TEMPO section

7 TIME CODE GENERATOR section

5TIME CODE READER section

Synchronous signal section

1SAMPLING FREQUENCY buttons Touch the button corresponding to the desired sampling frequency from 44.1 kHz, 48 kHz, 88.2 kHz or 96 kHz.

Note

When 88.2 kHz or 96 kHz is selected, the frequency range expands to 40 kHz. However, the following functions are limited. Buttons corresponding to the limited functions are disabled.

•Input channel: The channel number is reduced from 48 to 24.

76 Chapter 3 Menu

•AUX Send: The channel number is reduced from 8 to 2.

•AUX Return: The channel number is reduced from 8 to 4.

•MTR bus: The channel number is reduced from 8 to 4.

•Insertion send: The channel number is reduced from 8 to 4.

•Direct out: The channel number is reduced from 48 to 24.

•Optional boards: DMBK-R106 and DMBK-R107 cannot be used.

The DMBK-R104 cannot be used for a channel where the sample rate converter is set to ON.

•Surround mode is not available.

•The number of oscillator paths becomes one and the same signal is outputted to both the L and R channels.