AUDIO OUTPUT ROUTING Window
To open this window, touch the AUDIO button on the bottom menu bar, then select “OUTPUT ROUTING”. This window allows you to assign the bus output signal to the desired output connector.
Block list | 4 Output connector select buttons |
5 INSERTION buttons
2 V button
1Bus select button
2 v button
3 DEFAULT button
3 Chapter Menu
1Bus select button
Displays the block (or bus) currently selected. Touch this button to open the list for the bus output blocks in the B direction. Touch the desired bus block to open the list of the busses included in the block.
The list of the block and its output bus list are as follows:
•PGM L/R L and R
•AUX
This block has 8 buses (AUX 1 to 8).
•MTR
This block has 8 buses (MTR 1 to 8).
•INS SEND
This block has 8 buses (Insert Send 1 to 8).
•DIRECT OUT 1 to 8 to 41 to 48 Each block has 8 outputs.
•MSC
This block has NC (NO CONNECTION), CR MONITOR 1 to 6 and ST MONITOR L/R.
2v/V buttons
Touch the V button to select the block above the selected block.
Touch the v button to select the block below the selected block.
3DEFAULT button
Touch this button to reset the setting of the output matrix to the default.
Chapter 3 Menu 57