Locations and Functions of Parts and Controls
2 Chapter and Locations
INPUT Section and BUS ASSIGN section
INPUT section
This section allows you to adjust the digital input signal. When the signal input is analog, you can adjust the converted digital signal.
Buttons and controls in the INPUT section are only available for snapshot automation and not dynamic automation.
1 ∅ button
Inverts the phase of the input signal.
2TRIM control
Trim level control for
3DELAY IN button
Press this button to enable the delay function.
4DELAY control
Adjusts the delay between 0 and 999 milli seconds (at the sampling frequency of 48 kHz).
BUS ASSIGN section
Buttons in the BUS ASSIGN section are used for the snapshot automation function and dynamic automation function.
5MTR 1 to 8 buttons
Press the button to route the accessed channel to the selected MTR bus.
6PROGRAM L/R buttons
Press the PROGRAM L button to route the accessed channel to the left PGM bus.
Press the PROGRAM R button to route the accessed channel to the right PGM bus.
of Functions
and Parts
Controls
DYNAMICS section
| 1 DYNAMICS IN button |
|
| 2 Dynamics access section | ||
|
| DYNAMICS |
|
|
| |
DYNAMICS IN | THRESHOLD RATIO | ATTACK | HOLD | ACCESS | IN | |
EXPAND |
| |||||
|
|
|
|
|
| |
|
|
|
|
| GATE |
|
|
|
|
|
| ACCESS | IN |
|
| RANGE |
|
| COMPRESS |
|
|
|
| RELEASE | DUCK |
| |
|
| GAIN |
|
|
| |
PRE EQ | POST EQ |
|
|
|
| |
|
|
|
|
| ||
3Dynamics insertion point buttons
4 Dynamics parameter section
18 Chapter 2 Locations and Functions of Parts and Controls