AUX SEND Window

To open this window, touch the CHANNEL button on the bottom menu bar, then select “AUX SEND.” Or, when the CHANNEL window is displayed, touch any point on the AUX SEND display. This window allows you to display and control the settings for AUX SEND 1 to 8.

The ON button and PRE button on the window have the same function as those of the AUX SEND section on the Parameter Setting panel.

By touching the display window where the numerical values are displayed, these items are switched to READY or DROP IN/OUT of automation WRITE.

1Display window

In stereo mode, the even channels indicate the panning setting.

2ON button

3PRE button

3 Chapter Menu

1Display window

Displays the levels of the AUX SEND 1 to 8 busses. The level of the AUX send bus is adjusted using AUX SEND controls 1 to 8 on the AUX SEND section on the Parameter Setting panel.

When the AUX send bus is set to stereo mode, the display windows of the even channels indicate the panning/balance settings.

To set the AUX SEND bus to stereo mode, select the MASTER button on the PAGES section and then access one of the AUX SEND faders. On the display, select STEREO using the channel mode select button on the CHANNEL window.

2ON buttons 1 to 8

Touch the desired button to light it up. The accessed channel is sent to the corresponding AUX send bus. For busses set in stereo mode, the pairing of the odd and even channel is 1 and 2, 3 and 4, 5 and 6, and 7 and 8.

3PRE (prefader) buttons 1 to 8

Touch the desired button to light it up. The pre-fader signal of the channel is routed. When the button is routed, the post-fader signal is sent out.

For buses set in stereo mode, the odd and even channels are linked, the PRE button of the even channel toggles the pan on and off.

Chapter 3 Menu 49