Basic Components and Functions of the Windows
3 Chapter Menu
•After executing KEEP, do not turn off the power while the cursor indication changes to an arrow showing that the data has been processed or while the LED on the floppy disk drive is on. In such a case, the unit is writing the data in the flash memory or is storing in the floppy disk. If you turn off the unit during this process, the Current Title may be lost.
2Snapshot display
The name of the snapshot last recalled is displayed on the SNAPSHOT button.
3AUTO (automation) MODE display
Displays the Automation mode and return time mode settings.
AAutomation operation B Automation return mode:
mode: ABS |
|
| BUTT | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CPunch in mode: AUTO
AAutomation operation mode
•ABS: Automation is in the ABSOLUTE (absolute value) mode. In ABS mode, the display lights red. (When the SAFE button is lit on the console, the display is dark red.)
•TRIM: Automation is in the TRIM (fine adjustment) mode. In TRIM mode, the whole display is green. (When the SAFE button is lit on the console, the display is dark green)
•OFF: Shows the automation is off. In OFF mode, the
whole display is black.
For information on the fader operation and its results in ABS mode and trim mode, see page 100.
BAutomation return mode
Sets the automation return mode when the Drop Out function is performed.
BUTT: When the automation is dropped out (i.e. changes from WRITE mode to READY status), the faders and other controls immediate jump back to the position stored in the previous data.
RAMP: Faders and other controls ramp back to the position stored in the previous data in a number of frames.
NEXT: Holds the position to the next event (recorded in the dynamic automation).
TO END: Holds the position to the end and renews the automation data. (HOLD TO END)
CPunch in mode
•NORMAL: The punch in/punch out functions are not set.
•FOOT: Punching in/punching out using the foot switch is set.
•AUTO: An auto punch is performed according to a specified time entered on the Automation window.
4READY SETUP button
Dark yellow (OFF): Normal status
Light yellow (ON): Ready setup status (Available to set READY/SAFETY)
Normally, this button is dark yellow (READY SETUP is off). In this case, the buttons, controls and switches directly control the audio processing.
When you touch the button shown, it turns light yellow. This allows you to select controls to the READY status.
Now, when you operate the controls, they switch between READY active and READY off, and the controls do not control the audio processing. Press READY SETUP again to revert the controls to audio processing.
With READY SETUP on, controls switch as follows: Buttons: Whenever you operate the buttons on the panel and window, the READY status is switched. Controls: Turning them clockwise results in setting them to READY. Turning them counterclockwise results in setting them to SAFETY. Also touching the numerical value on the display window results in switching READY/SAFE.
Faders: Whenever you touch the fader, READY/ SAFE is switched. Also pressing the numerical value on the display window results in switching READY/ SAFE.
38 Chapter 3 Menu