AAutomation return mode button
Touch this button to select the mode that returns to the previous data.
BUTT: Returns to the previous data quickly after the
DROP OUT.
RAMP: Ramps back to the previous position after the
DROP OUT.
HOLD TO NEXT: Holds the position after the DROP OUT until the next automation move is replayed. HOLD TO END: Holds the position after the DROP OUT.
BRAMP frame display
Sets the time to return to the position stored in the previous data in unit of frame.
You can set the desired number of frames using the m/
Mbuttons.
4PUNCH IN/OUT section
This section allows you to punch in and out of dynamic automation WRITE by sending the ON/OFF signal or specifying the timecode.
FOOT SW button: Touch this button to active the foot switch automation WRITE control. When this button is not selected, the foot switch status is ignored. AUTO button: Touch this button to enable the PUNCH IN TIME/PUNCH OUT TIME display windows. When this button is not selected, automation data is stored regardless of the values in the PUNCH IN/OUT TIME windows.
PUNCH IN TIME button and display window: Touch this button to accept the time displayed on the timecode display window on the Automation panel. This time is then displayed in the windows.
You can enter the timecode using the ten keys by touching the timecode on the display window. Remember to press the ENTER button to accept this value.
You can increase or decrease the numeric values using the + / - buttons and the jog dial.
PUNCH OUT TIME button and display window: Touch this button to accept the time displayed on the timecode display window on the Automation panel.
This time is then displayed in the window.
You can enter the timecode using the ten keys by touching the timecode on the display window. Remember to press the ENTER button to accept this value.
You can increase or decrease the numeric values using the + / - buttons and the jog dial.
5AUTOMATION ISOLATE tab
Selects the channels or functions that you want to isolate from automation replay.
Touch this tab, then touch the CHANNEL button(s) and FUNCTION button(s) for the functions you want to isolate.
6MAKE STATIC tab/qa MAKE STATIC EXECUTE button
To select the channels whose automation data you want to delete, touch the MAKE STATIC tab 6, then touch the desired CHANNEL button(s).
Touching the MAKE STATIC EXECUTE button after selecting the channel results in clearing all the automation data from that channel.
7Channel buttons (CH1 to PGM)
After selecting the AUTOMATION ISOLATE tab 5 (or MAKE STATIC tab 6), select the channel that you want to isolate from automation replay (or the channel that you want to delete) using these channel buttons.
8ALL OFF button
Touch this button so that no channels are selected.
9ALL ON button
Touch this button to select all channels.
0FUNCTION ISOLATE buttons
Touch the button to remove the mixer’s functions from automation replay. The function corresponding to the selected button is not loaded when replaying automation files.
3 Chapter Menu
Chapter 3 Menu 69