MS DECODE button: Inserts a middle/side decoder to convert the odd numbered chanel ( M - Mid- capsule) and even numbered channel (S - Side- capsule) to Left and Right. This is only active in STEREO mode.

These signals are converted to right and left signals before the channel faders.

2ASSIGN section

MTR button and PROGRAM button: Touching these buttons results in the output of the displayed channel being assigned to the corresponding the MTR or PROGRAM buses.

PRE EQ button: When this button is ON, the signal before the equalizer/dynamics circuit is sent to the MTR bus.

PRE FDR button: When this button is ON, the signal before the channel fader is sent to the MTR bus. POST FDR button: When this button is ON, the signal after the channel fader is sent to the MTR bus. If the PRE EQ button, the PRE FADER button or the POST FDR button is selected, the remaining two buttons are cleared.

3SURROUND PAN section

To switch the MTR buses to Surround, the SURROUND button must be “ON” in the MTR BUS MODE section of the MISC SET UP window.

When the unit is in normal mode, this section is not active. For channels set to stereo link, the surround panning for the right channel and left channel can be set individutally.

For detailed information on the MISC SETUP window, see page 84.

AL,C,SW,R buttons

B WRITE button

C Surround pan display/operation area

D DIV display window, SET button and jog dial

A LS button

A RS button

ESurround position button

AL (left), C (center), R (right), LS (left surround) , RS (right surround) and SW (sub woofer) buttons These have the same functions as the MTR button on the unit.

The assignment of MTR buses to the surround send outputs is as follows.

•L button t MTR 1 bus

•C button t MTR 3 bus

•R button t MTR 2 bus

•LS button t MTR 5 bus

•RS button t MTR 6 bus

•SW button t MTR 4 bus

BWRITE button

Touch this button to switch the surround pan to READY and to DROP IN/OUT of automation

WRITE.

CSurround pan display/operation area

In surround mode, you can set the surround panning in this area. Touch this area, then drag the icon to the desired point.

DDIV display window, SET button and jog dial In surround mode, by touching the SET button, you can set the divergence value (ratio of the divergence among L channel, center channel and R channel) using the jog dial on the unit. The set divergence value is displayed on the DIV window.

Touching the DIV display window allows you to set the mode to READY and to DROP IN/OUT of automation WRITE.

ESurround position button

Touch this button to access the nine preset surround pan positions. You can set the surround position by selecting the icon corresponding to the desired type from the list.

4MTR PAN section

Displays the panning operation status of the MTR bus. Touch this button to set pan on or off.

Note

The MTR pan in surround mode is linked with the LgR direction of the surround pan. When the surround pan is set to ON, the MTR pan is set to ON.

5PAN section

Displays the normal panning operation status. Touch this button to set pan on or off.

3 Chapter Menu

Chapter 3 Menu 45