3 Chapter Menu

Menu Windows

INPUT/PAN/ASSIGN Window

To open this window, touch the CHANNEL button on

Note

 

the bottom menu bar, then select “INPUT/PAN/

When setting a channel or an aux send master to

ASSIGN.” Or, when the CHANNEL window is

STEREO mode, DYNAMICS, EQ, AUX SEND

displayed, touch any point of the INPUT/PAN/

LEVEL, AUX PRE, CUT , FADER and MTR SEND

ASSIGN display.

operate in stereo mode.

 

 

 

 

 

3 SURROUND PAN section

1INPUT section

Mode button

Unit selection button

2 ASSIGN section

 

 

 

 

 

 

 

4 MTR PAN

 

section

 

 

 

5 PAN section

1INPUT section SOURCE section

Displays the source currently selected.

To change the source, touch this button to open the list of available inputs.

TRIM section

Display window: Displays the input gain trim setting that are controlled by the TRIM control on the Parameter Setting panel.

∅button: Touching this button inverts the phase of the input signal. In its normal state, the button color is gray. When the phase is inverted, this button color changes to green.

Delay section

Display window: Displays the setting of the programmable delay amount that are controlled by the DELAY control on the Parameter Setting panel.

IN button: Touch this button to turn the delay ON or OFF on the window. In its normal state (when the delay is off), the button color is gray. When the delay is on, this button changes to green.

Unit selection button: Touch to select the delay mode to SAMPLE, mS or FRAME units. Each unit has two adjusting modes: NORMAL mode (adjusts in minimum units) and COARSE mode (rough adjustment).

When you change the delay mode, if the displayed mode and actual delay amount are different units, a yellow f appears over the unit display in the window.

MODE section

MODE button: Toggles between MONO and STEREO link mode.

When STEREO is displayed on the button, adjacent channels, (i.e. channels 1 and 2), operate in stereo mode. The odd channel is L and the even channel is R. The REVERSE, L + R and MS DECODE buttons are active, only when the STEREO button is lit. REVERSE button: When this button is lit, the right and left are swapped.

L + R button: When this button is lit, the right and left channels are mixed (L + R signal).

44 Chapter 3 Menu