The Pattern Editor
AWG610 Arbitrary Waveform Generator User Manual 3-81
Table3-25: Code conversion commands
Commands Description
Open... Reads an existing code conversion table.
Save... Saves a code conversion table that was newly created or
edited. It is saved in an ASCII file and the cells are separated
by commas.
Edit... Creates or edits a code conversion table.
When you push the Edit... side button, the code conversion table appears as
shown in Figure 3–15. Each code conversion table defines the template pattern
that is used for pattern matching with the source code. Use the Edit... side button
to create a new code conversion table. Alternatively, use the Open... side button
to read an existing code conversion table.
Figure 3-15: Code conversiontable
Table3-26: Code conversion parameters
Parameters Description
Past Source Corresponds to the previous source data, which is to the left of the current
noticed point. Youcan view up to eight points of past data.
Current Source Showsthe source data you are currently looking up. You may specify up to
16 points, starting in the noticed point.
Next Source Specifies the source pattern that is further to the right of the portion read
with Current Source. Youcan look at up to eight points of data.
Code Conversion Table