Operating Basics
AWG610 Arbitrary Waveform Generator User Manual 2-37
To edit the loaded waveform file, push the Edit... side menu button. The
instrument opens the appropriate edit window for the previously loaded file type.
If you have not loaded a file in the Setup screen, the instrument displays the
message No output data, and you cannot enter into the editor.
The editors are described in more detail in the Reference section beginning on
page 3–45.
The Setup side menus provide commands for setting and adjusting waveform
output parameters. The steps for setting output parameters are discussed in detail
in the Reference section beginning on page 3–29. Table 2–14 provides an
overview of the Setup side menu operations.
Table2-14: Setup output parameter operations
Bottom
button
Side
button Description
Waveform/
Sequence
Load...
View
Edit...
Ez FG...
Displays the Select File dialog box that lists files in the current
drive and directory.Select a file to load or use the side menu
buttons to change drives and/or directories.
Displays the loaded file in a window.Push the OK side menu
button to close the view window.
Opens the appropriate editor for the loaded file.
Enters the FG mode for easy generate of standard functional
waveform.
Vertical Amplitude
Offset
Filter
Marker...
Direct Out...
Sets the signal peakĆtoĆpeak amplitude in increments of 0.002 V.
The maximum value is 2 VpĆpin normal mode and 1 VpĆp in direct
mode. Use the general purpose knob or the keypad to enter new
values.
Sets the signal offset value in increments of 0.002 V.The offset
voltage range is ±1 V.Use the general purpose knob or the
keypad to enter new values.
Selects lowpass filter to insert into signal path. Filter values are
Through (no filter), 20 MHz, 50 MHz, 100 MHz, and 200 MHz. Use
the general purpose knob to enter new values.
Displays a side menu to set Marker 1 and Marker 2 signal high
and low values. The marker signal voltage range
is -1.1 VĂtoĂ3.0 VĂandmaximumĂamplitudeĂisĂ2.5VpĆp into 50 W.
Use the general purpose knob or the keypad to enter new values.
Selects to connect the DAC output directly to the channel
connector.
Editing a WaveformSetting Waveform OutputParameters