Capturing Waveforms
3-172 AWG610 Arbitrary Waveform Generator User Manual
Procedures for Capturing Waveforms
Do the following steps to capture a waveform:
1. Set the GPIB parameters in the AWG610 Arbitrary Waveform Generator.
The AWG610 Arbitrary Waveform Generator must be set to the controller.
Refer to Connecting to a GPIB Network on page 3–153 for setting the GPIB
parameters.
2. Set the GPIB address and Talk/Listen mode in the source instrument.
3. Start acquisition in the source instrument.
Do the following steps to capture the waveform:
1. Push EDIT (front-panel)Tools (bottom)Capture Waveform (side).
The dialog box listing the instruments appears as shown in Figure 3–57.
Figure 3-57: Source instrument selectiondialog box
a. If necessary, select Others... to open the other source instrument list.
The dialog box listing the instruments appears as shown in Figure 3–58.
b. Select a source instrument from the list.
c. Push the OK side button.