The UTILITY Window
3-158 AWG610 Arbitrary Waveform Generator User Manual
The ping command sends a packet to the remote computer specified by the
IP address. When the computer receives the packet, it sends the packet back
to the sender (your AWG610 Arbitrary Waveform Generator).
When the AWG610 Arbitrary Waveform Generator can communicate with
the remote computer through the network, the message as shown in
Figure 3–49 is displayed. If it failed to establish the communication, the
message box displaying an error message such as Unknown error is
displayed.
5. Repeat steps 2 and 3 for all the remote computers to which you desire to
verify the connection through the network.
Figure 3-49: Message box to indicatethe establishment of communication
You can set the FTP Version and NFS Timeout time. Do the following steps to
set these parameters.
1. Push UTILITY (front-panel)Service (bottom)Tweak AWG1 (pop-
up)OK (side).
2. Push NFS Timeout (side) and set the NFS Timeout time using the general
purpose knob or the numeric keypads. The time range is from 25 to 300
seconds.
3. Push FTP Version(side) button to toggle between Standard and Obsolete.
Usually, set Standard.
Figure 3-50: Network Status screen
Network Parameter