The UTILITY Window
AWG610 Arbitrary Waveform Generator User Manual 3-167
The manual diagnostics routines can execute a full set of hardware tests for all
the test categories or only for the specified category except for the DAC. You can
also specify a test cycle of 1 to infinite times.
Do the following steps to execute the diagnostics:
1. Push the RUN button to turn the output off if a waveform is being output.
The RUN LED turns off.
2. Push UTILITY (front-panel)Diag (bottom).
The screen shown in Figure 3–55 appears.
3. Push the Diagnostic xxxx side button and select a test category by using the
general purpose knob.
The xxxx represents currently selected test category. You can select a test
category from All, System, Run Mode, Clock, Output, Seq Mem and Wave
Mem. If you select All, the diagnostic routines of all categories are executed.
4. Push the Cycle n side button and select a test cycle by using the general
purpose knob.
The n represents a currently selected test cycle. You can select a test cycle
from 1, 3, 10, 100 or Infinite. If you select Infinite, the diagnostic tests are
repeated infinitely. Push the Abort Diagnostic side button to stop the
execution.
5. Push the Execute Diagnostic side button to start the diagnostic tests.
The - - - is displayed at each test category on the screen either at the beginning or
after the factory reset. The mark - - - is also displayed while the diagnostic test is
executing. See Figure 3–56. When the diagnostic test terminates without error,
Pass is displayed instead of the - - -. The test routine displays the error code and
skips to the next test if an error is detected.
See Table 3–45 for the test categories and error codes.
Table3-45: Diagnostic categories and error codes
Categories Error codes Descriptions
System 2101 to 2106 Bios test error
2111to 2116 FrontĆpaneltest error
2301 A30 board test error
2401 to 2402 Clock delay data test error
2701 to 2702 Cal data test error
Manual Diagnostics