Tektronix AWG610 Inserting a Line, Cutting a Line, Copying a Line

The Sequence Editor
3-114 AWG610 Arbitrary Waveform Generator User Manual
HWhen you set the value in the Repeat Count, the a and ' buttons are
assigned to shift the numeric values. To move the cursor horizontally, push
the TOGGLE or CLEAR MENU on the front-panel. Use the a and ' button
to move the cursor.
HThe side menu corresponding to the Data Entry bottom button varies with
the parameter value in the cursor position.
When you first open a new sequence table, a table containing 0 lines is created.
You must insert new lines into the table before you can edit the contents. To
insert new lines, use the Insert Line command as follows:
1. Move the cursor to the position that you want to insert a new line. If this is a
new table, you are already at the place to insert a new line.
2. Push Data Entry (bottom)Insert Line (side).
A new line is created immediately above the line of the current cursor
position.
If you insert a new line into a table that contains line jump numbers, the
instrument automatically updates the table line numbers and the jump line
numbers.
. The maximum number of lines in a sequence table is 8000.
You can cut a selected line to the paste buffer. Do the following steps to cut a
line:
1. Move the cursor to select the line that you want to delete.
2. Push Line Edit (bottom)Cut Line (side).
The instrument deletes the selected table line. You can use the Paste Line
command to insert the cut line into a new position in the table.
. After cutting a line from the table, the table automatically updates all
current and destination line numbers for jump operations. If you cut a line that
was specified as a jump destination, the jump setting is set to Off (no jump).
Reinserting the cut line will re-establish the jump connections.
You can copy a selected line to the paste buffer. Do the following steps to copy a
line:
Inserting a Line
Cutting a Line
Copying a Line