Tektronix AWG610 Connecting to the Ethernet

The UTILITY Window
3-156 AWG610 Arbitrary Waveform Generator User Manual
You can connect the AWG610 Arbitrary Waveform Generator to a 10 BASE-T
Ethernet network. To mount a remote file system or to control the instrument
from an external computer, you must set the following parameters in the
instrument:
HSelect Network for remote control through Ethernet
HIP address and Subnet Mask for the AWG610 Arbitrary Waveform Generator
HUp to three gateway addresses (if necessary)
Figure 3–48 shows the setup screen menu that you can use to set the network
parameters to your AWG610 Arbitrary Waveform Generator.
Set the three previous parameters to remote-control the instrument. Set at least
the last two parameters to use FTP or NFS for file transfer.
Network setup parameters
Figure 3-48: Network setup screenmenu
To let the network recognize the AWG610 Arbitrary Waveform Generator, set the
IP address and Subnet Mask. If necessary, also set the Gateway address by
following the steps below:
1. Push UTILITY (front-panel)Comm (bottom) to display the network setup
screen menu.
2. Select Network for remote control.
a. Select Remote Control using y and b buttons.
Connecting to the
Ethernet