Thermador PRD48, PRD36 manual Using the Oven, Extended Cooking Functions, Kitchen Timer, Cook Timer

Using the Oven

Extended Cooking Functions

Oven Setting Controls

1.ENTER verifies a selection

2.(-) decreases and (+) increases time and/or temperatures, it is also used to scroll through menu items: Kitchen Timer, Cook Timer, Offset, and Sabbath oven functions.

3.CANCEL clears all oven operations.

Figure 26: Oven Setting Controls

Kitchen Timer

The Kitchen Timer can be set for up to 12 hours. It can be used despite whether the range is in operation and independently of all other functions. The kitchen timer is non-operational when the steam oven is in a cooking mode (PRD486JDSG model only).

Cook Timer

The Cook Timer is intended to mechanically shut the oven off when the desired cooking time is complete. Cook timer is only available for Bake, Convection Bake, Roast, and Convection Roast. It is not available for Broil, Convection Broil, or Self Clean. The Cook Timer can be activated at anytime during the cooking cycle.

To set the timer:

1.Press ENTER.

2.Use the “+” and “-” buttons to select either KITCHEN TIMER or COOK TIMER.

3.Press ENTER.

4.Press the “+” and “-” buttons to select desired time.

5.A beep sounds when the timer ends. Press CANCEL terminate the beep and timer.

Note:

•Cook Time cannot be used if a temperature probe is in use.

•The maximum Cook Time setting is 12 hours.

Using the Offset Feature

The OFFSET feature is located at SETTINGS > OFFSET. It allows the cook to further fine-tune their cooking parameters to their own personal optimal settings by allowing them to adjust the temperature offset of the oven by +/-95°F (35°C) in increments of 5°F. For example, if the cook judges the oven temperature as too hot and wants to lower it by 5°, press the “-“ button, and vice versa for positive temperatures. This feature is useful if you find that food is consistently either too brown or too light for your tastes.

•The oven must be turned off in order to set an offset value.

•The Offset feature is available for all modes except Self-Clean.

•By default, the temperature is set at 0°.

•The unit will continue to run the inputted offset value indefinitely until the user manually chooses to render it otherwise or until the unit loses power, in which case Offset will need to be reset.

English 23