Toshiba 556. 656, 6540C, 5540C Press File, Make sure that MFP Local is selected and highlighted

2 BASIC OPERATION

3 Press [FILE].

yTo store the scan in the equipment’s shared folder, proceed to step 4.

yTo store the scan in a network folder, proceed to step 5.

Storing data in a network folder requires the administrator to set the equipment configuration. For details, refer to the TopAccess Guide.

For the models below, press [PREVIEW] in this step and then select the scan function in order to preview your scans at the end of the operation.

-e-STUDIO4540C Series

-e-STUDIO6550C Series

-e-STUDIO2550C Series (only when the hard disk is installed)

For instructions on how to do so, see the following section:

P.56 “Previewing Scans”

4 Make sure that [MFP LOCAL] is selected and highlighted.

Proceed to step 9.

If saving data in a network folder is enabled by the administrator, you can select 2 file destinations from [MFP LOCAL], [REMOTE 1] and [REMOTE 2]. If you select [MFP LOCAL], you can specify a network folder (REMOTE 1 or 2) as a remote destination. To set a network folder as a remote destination, proceed to step 5.

For equipment with no hard disk installed, only either [REMOTE 1] or [REMOTE 2] can be specified as a file destination. [MFP LOCAL] and more than one destination cannot be specified.

Scan to File 19