2 BASIC OPERATION
7 If the screen below appears, place another original on the original glass and press [SCAN] or the [START] button to continue scanning. To finish the job, press [JOB FINISH], followed by the [FUNCTION CLEAR] button.
yThe above screen is not displayed under the following conditions:
-You scan the original from the Reversing Automatic Document Feeder without pressing [CONTINUE] to scan additional originals.
-A scan preview is displayed.
yTo cancel the operation, press [JOB CANCEL].
yTo change the scan settings, press [SCAN SETTING].
P.46 “Changing Scan Settings”
yWhen the equipment has scanned more than 1000 pages in a job, the “The number of originals exceeds the limits. Will you save stored originals?” message appears. If you want to save the scans, press [YES].
If no hard disk is installed in the equipment, scanned originals cannot be saved in the equipment, however scanning can be performed until its memory is full. For the approximate number of pages which can be scanned, see the following section:
P.18 “Scan to File”
yWhen the temporary workspace is full on the equipment’s hard disk, a message appears and the job is canceled. The available workspace can be viewed on the TopAccess [Device] tab.
yIf the number of jobs waiting to store scans in the equipment's hard disk exceeds 20, a message appears to indicate that the equipment’s memory is full. In this case, wait a while until memory becomes available again or delete unnecessary jobs from [JOB STATUS].
P.42 “Viewing the scan job status”
