Toshiba A200 manual Replacing TMD fluorescent lamp6

4 Replacement Procedures 4.26 Fluorescent lamp

5.Removing PCB-ASSY cell <Procedure>

1)Remove the PCB-ASSY cell from the back light unit.

2)Remove thoroughly remaining double-sided tape on the back of cell.

Caution: 1. One point of the upper of cell is fixed with double sided tape. Peel off slowly so as not to break the cell.

2.Be careful not to peel off the light-shield tape at the upper, lower, right and left.

Cell with PCB

Remove the cell while peeling off the double -sided tape (1 point).

Figure 4-55 Replacing TMD fluorescent lamp(6)

4-66 PORTEGE A200 Maintenance Manual (960 -499)