LAN Port (Net0) Configuration

LAN port configuration lets you configure the NETServer’s Ethernet interface.

If you have changed the IP address or IPX network number, you must reboot the NETServer after you save your changes.

How to . . .

Bring Up the List of Commands

To bring up a list of commands for Net0 configuration, use the following command:

help set net0

Reset the Network Interface Card

To reset the Network Interface Card, use the following com- mand:

reset nic

Note that unlike other ports, you do not reset the LAN port after you have finished configuring it. Instead, you reboot the NETServer.

Save Changes

Since there is no save net0 command, you must use save all to save LAN port configuration. Type the following command:

save all

10-24 Command Reference

Page 174
Image 174
USRobotics NETServer/8, NETServer/16 manual LAN Port Net0 Configuration, Reset the Network Interface Card