Ports Table (S-port configuration)
The
How to . . .
Bring Up the List of Commands
To bring up a list of commands and command options for the ports, use the following command:
help set s<port #>
Change a Port’s Parameters
To change a port’s parameters, use the following command:
set s<port #> <command> <option>
For example, to set serial port S1’s Modem Control to On:
set s1 modem on
Save Port Configuration
It is important to understand that the NETServer actually stores port configuration in three different areas:
∙Default configuration (in RAM memory)
∙Active configuration (also in RAM)
∙Permanent configuration (Flash memory)
The NETServer does not actually use the default configuration. The default configuration is instead simply a work area in memory that stores all the changes you have made using set commands.
The active configuration is the port configuration the NETServer is actually using. It can only be changed by resetting a port, which copies the default configuration for that port into the active configuration area.
