USRobotics NETServer/16, NETServer/8 manual SDL Command Syntax, Software Download C-3

PCSDL commands can be in either upper or lower case letters. Leave one space after each command line parameter. The d command is optional, the rest are required.

Note: After the Install utility copies files to your hard disk, it is important not to change the file names or try to edit the files. This will cause an error message to be displayed when you run the SDL program. You will also need to know these file names to launch SDL.

The table below shows what the file name means:

Filename	Prefix	Version #	File Type
pn030100.nac	pn	3.1.0	NAC
	(NETServer/8)	(03 01 00)
tr010200.sdl	tr	1.2.0	SDL
	(NETServer/8)	(01 02 00)

SDL Command Syntax

The following is a sample of the command syntax based on the sample file names above. The table that follows explains each parameter.

pcsdl -p1 -r57600 -vsd1.2.0 -vna3.1.0 -nsdtr -nnapn

Parameter	Purpose
pcsdl	initiates the PC SDL program
-p	selects communication port on the PC cabled to
	the NETServer (required); possible ports are 1, 2,
	3, or 4.
-r57600	selects serial port transmission rate of 57600 bps
-vsd	software download file version number (re-
	quired)
-vna	software .nac operation code version number
	(required)
-nsd	specifies the .sdl filename prefix (required):
	(tr = NETServer/8 and NETServer/16 SDL file)

Software Download C-3