Host

This field defines which network host the user’s session is forwarded to. Use the following command:

set user <user name> host <default prompt IP address>

Default Consult the ports table to obtain the default host for the port the user has dialed into and connect the user to the host listed there.

Prompt Allow the user to select a host (either by IP address or name) to begin a login session.

IP address Connect the user to the host whose address is entered here. This must be a valid name or IP address.

Service

This is the Login Service the user is configured for. The default is Telnet. Use the following command:

set user <name> service <rlogin telnet netdata portmux>

Telnet

Supported by most TCP/IP computers, Telnet lets

 

the user log in to hosts that support it. If you set a

 

terminal type, Telnet will pass that information

 

along. Otherwise, it negotiates a standard, Net-

 

work Virtual Terminal interface.

Rlogin

Although Rlogin was originally a (BSD) UNIX only

 

protocol, it is now supported by some non-UNIX

 

machines as well. Unlike Telnet, Rlogin allows a

 

user logged into a host, to access their accounts on

 

other (trusted) hosts without reentering a pass-

 

word. Rlogin requires that you specify a terminal

 

type.

PortMux

(Default) PortMux is similar to Telnet except that it

 

multiplexes many Telnet sessions into a single data

 

stream that’s more efficient to transmit and requires

 

fewer connections. PortMux requires that the host

 

be running a special PortMux daemon (in.pmd).

 

Note that this daemon also allows the host to use

 

NETServer ports set to Host Device as pseudo

 

TTYs (See Chapter 7). A UNIX version of the

 

PortMux daemon is available on the U.S. Robotics

 

web site.

10-60 Command Reference

Page 210
Image 210
USRobotics NETServer/8, NETServer/16 manual Set user name service rlogin telnet netdata portmux