Visioneer MFC7050C owner manual Remote Commands Operation Details

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Retrieval Access Code (159 ), the system will signal you with two short beeps to enter a remote command.

	Remote Commands			Operation Details
91	Playing Voice Messages			After one long beep, the MFC plays the
				ICMs (Incoming Messages).
				Press 1 while listening to an ICM to play it
		1	(Go Back)	again. Press 1 before a message to return to
				the previous message.
		2	(Skip to Next)	While playing an ICM, you can skip to next
				message.
		9	Stop Playing	Stop playing the ICM.
93	Erase All ICMs			If you hear one long beep, the erase is
				accepted. If you hear three short beeps, you
				cannot erase because all voice messages
				have not been played, or there is no voice
				message to erase.
				* This code erases all recorded messages,
				not one at a time.

94Play and Record OGMs in Memory

1	Play	The MFC plays the OGM. To stop playing
		the OGM, press 9.
		After one long beep, start recording the
2	Record	OGM. Your recorded message will be played
		when you finish speaking. To stop recording,
		press 9.

95Changing Fax Forwarding/ If you hear one long beep, the change is

Paging Setting			accepted. If you hear three short beeps, you
			cannot change the setting because the
	1	OFF	conditions have not been met (Example:
			registering paging number). You can register
	2	Fax Forwarding	your fax forwarding number by using 4.
			FAX FWD NO (see page 12-14). Once you
	3	Paging	have registered the number, the MFC will
			automatically change to FAXFWD:ON
	4	FAX FWD NO.	mode. Then retrieve a Memory Status List
			by entering 961 (see page 12-13) to make
			sure the list now shows the correct Fax
			Forwarding number.

Message Center

M E S S A G E C E N T E R 12 -11