ZyXEL Communications 792H manual VPN Screens

Prestige 792H G.SHDSL Router

	Table 14-7 VPN IKE
LABEL	DESCRIPTION
Local Address Type	Use the drop-down menu to choose Single, Range, or Subnet. Select Single for a
	single IP address. Select Range for a specific range of IP addresses. Select Subnet
	to specify IP addresses on a network by their subnet mask.
IP Address Start	When the Local Address Type field is configured to Single, enter a (static) IP
	address on the LAN behind your Prestige. When the Local Address Type field is
	configured to Range , enter the beginning (static) IP address, in a range of
	computers on your LAN behind your Prestige. When the Local Address Type field is
	configured to Subnet, this is a (static) IP address on the LAN behind your Prestige.
End / Subnet Mask	When the Local Address Type field is configured to Single, enter the IP address in
	the IP Address Start field again here. When the Local Address Type field is
	configured to Range, enter the end (static) IP address, in a range of computers on
	the LAN behind your Prestige. When the Local Address Type field is configured to
	Subnet, this is a subnet mask on the LAN behind your Prestige.
Remote	Remote IP addresses must be static and correspond to the remote IPSec router's
	configured local IP addresses. The remote fields do not apply when the Secure
	Gateway Address field is configured to 0.0.0.0. In this case only the remote IPSec
	router can initiate the VPN.
	Two active SAs can have the same configured local or remote IP address, but not
	both. You can configure multiple SAs between the same local and remote IP
	addresses, as long as only one is active at any time.
Remote Address	Use the drop-down menu to choose Single, Range, or Subnet. Select Single with a
Type	single IP address. Select Range for a specific range of IP addresses. Select Subnet
	to specify IP addresses on a network by their subnet mask.
IP Address Start	When the Remote Address Type field is configured to Single, enter a (static) IP
	address on the network behind the remote IPSec router. When the Remote Address
	Type field is configured to Range, enter the beginning (static) IP address, in a range
	of computers on the network behind the remote IPSec router. When the Remote
	Address Type field is configured to Subnet, enter a (static) IP address on the
	network behind the remote IPSec router.

14-10 VPN Screens