ZyXEL Communications 792H manual Applying Filters and Factory Defaults, Ethernet Traffic

Prestige 791R G.SHDSL Router

Step 3. This brings you to menu 11.5. Enter the example filter set number in this menu as shown in the following figure.

Menu 11.5 – Remote Node Filter

Input Filter Sets: protocol filters= 3

device filters= Output Filter Sets: protocol filters= device filters= Call Filter Sets: protocol filters= device filters=

Press ENTER to Confirm or ESC to Cancel:

Figure 28-18 Sample Filter Rules Summary — Applying a Remote Node Filter Set

28.6 Applying Filters and Factory Defaults

This section shows you where to apply the filter(s) after you design it (them). Sets of factory default filter rules have been configured in menu 21 (but have not been applied) to filter traffic.

	Table 28-5 Filter Sets Table
FILTER SETS	DESCRIPTION
Input Filter Sets:	Apply filters for incoming traffic. You may apply protocol or device
	filter rules. See earlier in this chapter for information on filters.
Output Filter Sets:	Apply filters for traffic leaving the Prestige. You may apply filter rules
	for protocol or device filters. See earlier in this section for
	information on types of filters.
Call Filter Sets:	Apply filters to decide if a packet should be allowed to trigger a call.

28.6.1 Ethernet Traffic

You seldom need to filter Ethernet traffic; however, the filter sets may be useful to block certain packets, reduce traffic and prevent security breaches. Go to menu 3.1 (shown next) and type the number(s) of the

28-20 Filter Configuration