ZyXEL Communications 792H Editing ATM Layer Options, VC-based Multiplexing non-PPP Encapsulation

Prestige 791R G.SHDSL Router

Figure 24-6 Remote Node Filter (RFC1483 or ENET ENCAP Encapsulation)

24.5 Editing ATM Layer Options

Follow these steps to edit Menu 11.6 – Remote Node ATM Layer Options.

Step 1. In Menu 11.1, move the cursor to the Edit ATM Options then press [SPACE BAR] to toggle and set the value to Yes.

Step 2. Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.

There are two versions of Menu 11.6 for the Prestige, depending on whether you chose VC-basedor LLC- based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.

24.5.1 VC-based Multiplexing (non-PPP Encapsulation)

For VC-basedmultiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1 will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.

Menu 11.6 - Remote Node ATM Layer Options

VPI/VCI (VC-Multiplexing)

VC Options	for IP:	VC Options for Bridge:
VPI #= 0		VPI #= N/A
VCI #= 38		VCI #= N/A
ATM QoS Type= UBR		ATM QoS Type= N/A
Peak Cell Rate (PCR)= 0		Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= 0		Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= 0		Maximum Burst Size (MBS)= N/A

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Separate VPI and

VCI numbers must

be specified.

Figure 24-7 Menu 11.6 for VC-based Multiplexing (non-PPP Encapsulation)

Remote Node TCP/IP Configuration 24-9