ZyXEL Communications 792H manual Route IP Setup, Both , In Only or Out Only, RIP-2B or RIP-2M

Prestige 792H G.SHDSL Router

Figure 22-4 IP Alias Setup

Follow the instructions in the following table to configure IP Alias parameters.

Table 22-1 IP Alias Setup

FIELD	DESCRIPTION	EXAMPLE
IP Alias	Choose Yes to configure the LAN network for the Prestige.	Yes
IP Address	Enter the IP address of your Prestige in dotted decimal notation	192.168.2.1
IP Subnet Mask	Your Prestige will automatically calculate the subnet mask based on	255.255.255.0
	the IP address that you assign. Unless you are implementing
	subnetting, use the subnet mask computed by the Prestige
RIP Direction	Press [SPACE BAR] to select the RIP direction. Choices are None,	None
	Both, In Only or Out Only.
Version	Press [SPACE BAR] to select the RIP version. Choices are RIP-1,	RIP-1
	RIP-2B or RIP-2M.
Incoming	Enter the filter set(s) you wish to apply to the incoming traffic
Protocol Filters	between this node and the Prestige.
Outgoing	Enter the filter set(s) you wish to apply to the outgoing traffic between
Protocol Filters	this node and the Prestige.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.

22.1.3 Route IP Setup

You must enable IP routing for Internet access. You can enable IP routing in Menu 1 — General Setup. To edit menu 1, type in 1 in the main menu and press [ENTER]. Set the Route IP field to Yes by pressing

[SPACE BAR].

LAN 22-3