ZyXEL Communications 792H manual Applying an IP Policy, Ethernet IP Policies, Matched, Change

	Prestige 791R G.SHDSL Router
	Table 33-2 IP Routing Policy
FIELD	DESCRIPTION
Len Comp	Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
	Less, Greater, Less or Equal or Greater or Equal.
Source:
addr start / end	Source IP address range from start to end.
port start / end	Source port number range from start to end; applicable only for TCP/UDP.
Destination:
addr start / end	Destination IP address range from start to end.
port start / end	Destination port number range from start to end; applicable only for TCP/UDP.
Action	Specifies whether action should be taken on criteria Matched or Not
	Matched.
Gateway addr	Defines the outgoing gateway address. The gateway must be on the same
	subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the
	IP address of a remote node. The default gateway is specified as 0.0.0.0.
Type of Service	Set the new TOS value of the outgoing packet. Prioritize incoming network
	traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max
	Reliable or Min Cost.
Precedence	Set the new outgoing packet precedence value. Values are 0 to 7 or No
	Change.
Log	Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
	system log when a policy is executed.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

33.3 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

33.3.1 Ethernet IP Policies

From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet Setup.

You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for example, 2, 4, 7, 9.

IP Policy Routing 33-5