ZyXEL Communications 792H manual Clid, Nmbr

Prestige 792H G.SHDSL Router

	Table 5-4 Advanced Modem Setup
LABEL	DESCRIPTION
Drop DTR When	Select this check box to have the Prestige drop the DTR (Data Terminal Ready)
Hang Up	signal after the "AT Command String: Drop" is sent out.
AT Response
Strings
CLID	Type the keyword that precedes the CLID (Calling Line Identification) in the AT
	response string. This lets the Prestige capture the CLID in the AT response string
	that comes from the WAN device. CLID is required for CLID authentication. Example:
	NMBR
Called ID	Type the keyword preceding the dialed number.
Speed	Type the keyword preceding the connection speed. Example: CONNECT
Call Control
Dial Timeout	Type a number of seconds for the Prestige to try to set up an outgoing call before
	timing out (stopping). Example: 60
Retry Count	Type a number of times for the Prestige to retry a busy or no-answer phone number
	before blacklisting the number. Example: 0
Retry Interval	Type a number of seconds for the Prestige to wait before trying another call after a
	call has failed. This applies before a phone number is blacklisted. Example: 10
Drop Timeout	Type the number of seconds for the Prestige to wait before dropping the DTR signal if
	it does not receive a positive disconnect confirmation. Example: 20
Call Back Delay	Type a number of seconds for the Prestige to wait between dropping a callback
	request call and dialing the corresponding callback call. Example: 15
Back	Click Back to return to the previous screen.
OK	Click OK to return to the previous screen, then click OK to return to the next previous
	screen and click Apply to save the changes.
Cancel	Click Cancel to begin configuring this screen afresh.

5-20 WAN