ZyXEL Communications 792H manual Field Description Default, Nmbr =

			Prestige 792H G.SHDSL Router
		Menu 2.1 - Advanced WAN Setup
	AT Command Strings:		Call Control:
	Dial= atdt		Dial Timeout(sec)= 60
	Drop= ~~+++~~ath		Retry Count= 0
	Answer= ata		Retry Interval(sec)= N/A
	Drop DTR When Hang Up= Yes		Drop Timeout(sec)= 20
			Call Back Delay(sec)= 15
	AT Response Strings:
	CLID= NMBR =
	Called Id=
	Speed= CONNECT
		Press ENTER to Confirm or ESC to Cancel:
		Figure 21-2 Advanced WAN Setup
	Table 21-2 Advanced WAN Port Setup: AT Commands Fields
FIELD			DESCRIPTION	DEFAULT
AT Command
Strings:
	Dial	Enter the AT Command string to make a call.			atdt
	Drop	Enter the AT Command string to drop a call. “~” represents a one			+++ath
		second wait, e.g., “~~~+++~~ath” can be used if your modem has a
		slow response time.
	Answer	Enter the AT Command string to answer a call.			ata
Drop DTR When		Press the [SPACE BAR] to choose either Yes or No. When Yes
Hang Up		is selected (the default), the DTR (Data Terminal Ready) signal is			Yes
		dropped after the “AT Command String: Drop” is sent out.
AT Response String:
CLID (Calling Line		Enter the keyword that precedes the CLID (Calling Line Identification)		NMBR =
Identification)		in the AT response string. This lets the Prestige capture the CLID in
		the AT response string that comes from the WAN device. CLID is
		required for CLID authentication.
	Called Id	Enter the keyword preceding the dialed number.			TO

Dial Backup 21-3