Chapter 11 Interfaces

Figure 158 Configuration > Network > Interface > Cellular

The following table describes the labels in this screen.

Table 60 Configuration > Network > Interface > Cellular

LABEL

DESCRIPTION

Add

Click this to create a new cellular interface.

 

 

Edit

Double-click an entry or select it and click Edit to open a screen where

 

you can modify the entry’s settings.

 

 

Remove

To remove an entry, select it and click Remove. The ZyWALL confirms

 

you want to remove it before doing so.

 

 

Activate

To turn on an entry, select it and click Activate.

 

 

Inactivate

To turn off an entry, select it and click Inactivate.

 

 

Connect

To connect an interface, select it and click Connect. You might use this

 

in testing the interface or to manually establish the connection.

 

 

Disconnect

To disconnect an interface, select it and click Disconnect. You might

 

use this in testing the interface.

 

 

Object

Select an entry and click Object References to open a screen that

References

shows which settings use the entry. See Section 11.3.2 on page 230 for

 

an example.

 

 

#

This field is a sequential value, and it is not associated with any

 

interface.

 

 

Status

The activate (light bulb) icon is lit when the entry is active and dimmed

 

when the entry is inactive.

 

The connect icon is lit when the interface is connected and dimmed

 

when it is disconnected.

 

 

Name

This field displays the name of the interface.

 

 

Extension Slot

This field displays where the entry’s cellular card is located.

 

 

Connected

This field displays the name of the cellular card.

Device

 

 

 

ISP Settings

This field displays the profile of ISP settings that this cellular interface is

 

set to use.

 

 

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

Reset

Click Reset to return the screen to its last-saved settings.

 

 

11.5.1 Cellular Add/Edit Screen

To change your 3G settings, click Configuration > Network > Interface > Cellular > Add (or Edit). In the pop-up window that displays, select the slot that you want to configure. The following screen displays.

 

239

ZyWALL USG 50 User’s Guide