Chapter 45 System

45.8.1 Configuring Telnet

Click Configuration > System > TELNET to configure your ZyWALL for remote Telnet access. Use this screen to specify from which zones Telnet can be used to manage the ZyWALL. You can also specify from which IP addresses the access can come.

Figure 418 Configuration > System > TELNET

The following table describes the labels in this screen.

Table 222 Configuration > System > TELNET

LABEL

DESCRIPTION

Enable

Select the check box to allow or disallow the computer with the IP

 

address that matches the IP address(es) in the Service Control table to

 

access the ZyWALL CLI using this service.

 

 

Server Port

You may change the server port number for a service if needed, however

 

you must use the same port number in order to use that service for

 

remote management.

 

 

Service

This specifies from which computers you can access which ZyWALL

Control

zones.

 

 

Add

Click this to create a new entry. Select an entry and click Add to create a

 

new entry after the selected entry. Refer to Table 219 on page 695 for

 

details on the screen that opens.

 

 

Edit

Double-click an entry or select it and click Edit to be able to modify the

 

entry’s settings.

 

 

Remove

To remove an entry, select it and click Remove. The ZyWALL confirms

 

you want to remove it before doing so. Note that subsequent entries

 

move up by one when you take this action.

 

 

Move

To change an entry’s position in the numbered list, select the method and

 

click Move to display a field to type a number for where you want to put

 

it and press [ENTER] to move the rule to the number that you typed.

 

 

712

 

ZyWALL USG 50 User’s Guide