Section 4.
Installation Under Work
Bench
Fig. 4
The Model 725 can be mounted under a work bench by securing with two #8 screws (not supplied) through the mounting hole tabs located on the top cover.
Note:
Use of the monitor in this way precludes grounding a work surface through the snap connector on the bottom of the monitor. A static control work surface, if present, would require grounding separately through an additional ground cord.
When mounting the Model 725 Monitor under a work bench for non mobile use, remove the parking clip (Section 6) from the Model 725 Monitor using a small screwdriver. The Model 725 Monitor is now ready to mount.
Position the monitor so that it is convenient for the operator to plug their wrist strap ground cord into the jack on the front of the monitor. It is
recommended that the front face of the monitor be flush or slightly recessed from the front edge of the work bench. Attach the monitor to the work bench with the screws. It may be necessary to
Attach the dual conductor ground clip or each wire of the monitor’s dual conductor ground cord to a suitable ground.
Caution
If you decide not to use the dual conductor ground clip that is attached to the monitor’s ground cord in the way described in this user instruction manual, observe the following precaution: Attach each of the two wires of the monitor’s ground cord to separate ground bonding points. By attaching the wires to the same ground but at different physical locations, the monitor can check for loose or lost connections.
Use of an optional 3M 3057
and plugs into the 3057 jack which is mounted at the work station. Plugging into the 3057 jack prevents the Model 725 from continuously alarming when disconnected from the wrist band.
The system is now ready for use.
7