General Operations, Turning the power On/Off

MUTE / SENS

General Operations

Turning the power On/Off

Press the PWR to turn the unit On or Off.

Tip

When you turn on the unit, “HELLO” will be displayed then “WELCOME” will momentarily be displayed before actual power on.

When you turn off the unit, “SEE YOU” will be displayed then “GOOD-BYE” will momentarily be displayed before actual power off.

You can edit these messages. (See “Turn on/off message edit”).

Volume Control

Rotate the VOL dial to adjust the volume.

Volume up	+

VOL

Volume down

Muting the sound

Press .

To restore the previous volume level, pressagain.

Notes

• If the	CD	button is pressed when no CD has been loaded

into the unit, The CD mode will skip to the CD changer mode or AUX mode.

Also, if the CD changer is not connected, the system will move across to the AUX mode regardless of whether auxil- iary equipment is connected or not (“ AUX ” will be dis- played.)

•It is not possible to switch to the AUX mode when the CD changer is connected.

Setting the Clock

The clock uses a 12-hour display system.

1. Turn the ignition key to the ON position.

2. Press the PWR to turn on the unit.

3. Repeatedly press the DISP to display “CLK ADJ.

4. Use the following buttons and dial to set the clock. (The blink- ing section can be adjusted.)

SC/PS

: To switch Hour/Minute blink

Adjusting the Sound Characteristics		ENGLISH
2. Rotate the VOL dial to adjust the selected item.		ENGLISH
1.	Each time you press the AUDIO to select the desired ad-
	justment mode as table below.
	After pressing the AUDIO , you can also select with TUN/
	TRK dial or DISP .
	Use the following tables as a guide for adjusting the set-
	tings in each mode.
	Adjust within 5 seconds after selecting the item. After 5
	seconds, the unit returns to previous indication.

VOL

Adjustment Range

bAS B 0 (BASS)	B –5	~	B 0	~	B +5
TRE T 0 (TREBLE)	T –5	~	T 0	~	T +5
Ld LOUD	LOUD OFF		–		LOUD ON
bAS X-BASS	X-BASS 0		~		X-BASS 4
bAL B 0 (BALANCE)	B L9	~	B 0	~	B R9

Mute level can be adjustable. (See “Adjusting the Sound Characteristics”)

VOL

: Adjust the Hour and minute

FAd F 0 (FADER)	F R9	~	F 0	~	F F9
AU GAIN	–6	~	0	~	3
LMt LEVEL	0	~	50	~	80

Switching the Source (Selecting auxiliary input)

You can connect auxiliary equipment (Portable cassette player, etc) to this radio via optional AUX-IN cable. (See page 13)

Each time the		CD	is pressed, the operation source will

change over as shown below;
RADIO	CD CD changer or AUX

Press the BAND	to return to tuner mode.

5. Press the DISP momentarily to complete the Clock set- ting mode.

Ignition-off Clock Recall

The display will illuminate showing the time and then auto- matically shut off after 5 seconds.

Press the DISP while the ignition switch is in the “ OFF ” po- sition.

MUt LEVEL

•A italicized letter is an initial value.

E-3

SacramentoCD33_Eng

2/5/03, 4:27 PM