Skil 3700 manual Attaching Wings, Attaching Front Rails

Attaching Wings

!Wings and blank insert must be installed in WARNING order to use the table saw. Wings and blank

inserts create the complete table and support the workpiece. Use the jigsaw insert without the jigsaw attached for the second blank insert. Never use the sander or router insert in table saw mode.

Locate the two wings T6, T7, Allen wrench T19 and 10 Allen head bolts T20 (Fig. 9) from among the loose parts.

1.Remove wings from box. Orient them as shown in the picture, making sure that the red latch levers are oriented toward the front of the unit.

2.Attach each wing as shown using the Allen head bolts T20. Each wing should be fastened using five bolts. Firmly tighten the bolts using the Allen wrench T19 provided.

3.Attach the desired insert into each wing (see more information about inserts on pages 52-58).

FIG. 9

T7

T20

0º

5º

10º

15º

0º 2

º 0 3

	º
5
2

º 35

	º
0
4

4

T6

5º

Attaching Front Rails

Locate the two front rail pieces T8, T9, the connector T10, 4 spacers T21, 4 screws T20 and 4 nuts T22 (Fig. 10) from among the loose parts.

1.Make sure that the wings are properly installed with the red latch levers to the front of the table saw table.

2. Connect the two front rail pieces with the measurement scale on the top using the connector provided.

3. Insert the 4 screws through the rail and into the 4 spacers.

4. Align the rail with the holes in the front edge.

5. Insert screws into the front edge and tighten the 4 nuts to secure to the rail.

T7

FIG. 10

T21

T6

T22

T9

T10

T20

T8

44.